適用范圍

1. 塑料磨粉磨廢PE PP PVC粉磨機回收機用于硬質PVC回收領域,如次品和剩下的零碎東西，PVC管,PVC包裝和剩下的零碎東西，鋁塑料平板電腦,和銑削ABS, PS, PA, PC和其他塑料。

1. Plastic Pulverizing Milling Waste PE PP PVC Pulverizer Recycling Machine used in the field of hard PVC recycling, such as defective goods and leftover bits and pieces of PVC pipes, section bars and plates, PVC packaging and leftover bits and pieces of aluminum plastic tablets, and milling of ABS, PS, PA, PC and other plastics.

2. PE磨機的磨石最小直徑為350mm，最大直徑為800mm, PE磨機屬于磨石式磨機系列。廣泛應用于中等硬度的耐沖擊易碎材料，如PE、PVC等

2. The minimum and maximum diameters of the millstone of the PE mill are 350mm and 800mm respectively, and the PE mill belongs to the series of millstone-type mills. It is widely used in impact-resistant and fragile materials with moderate hardness, such as PE, PVC, PP, ABS, PA, EVA, PET, PS, PPS, EPS, PC, foam and cow leather.

產品特點

1. 新型的刀具結構，在旋轉葉片高速離心力的作用下，物料之間強烈的碰撞和靜止葉片板的剪切破碎。

1. The new cutter structure, strong collision between materials and shear crushing of the stationary blade plate in terms of the high-speed centrifugal force of the rotating blade.

2. 風冷水冷組合的使用，有效的控制了破碎物料的溫度，解決了熱敏性塑料磨后變性、熔融、燒焦等問題。

2. The use of air-cooled and water-cooled combination has effectively controlled the temperature for crushing materials and solved the problem of degeneration, melting and charring of heat-sensitive plastics after grinding and other problems.

3.機器的研磨室可以打開，方便刀具的修理和更換。

3. The grinding chamber of the machine can be opened, so that the cutter can be easily repaired and replaced.

4. 配備振動篩分設備，使粉末顆粒不能滿足要求的物料返回磨機進行再磨。

4. It is equipped with the vibration screening equipment, so that materials whose powder particles cannot meet the requirements shall be returned to the mill for re-milling.

5. 配備負壓送料除塵裝置，在提高物料排料速度的同時，避免了以往因正壓排料而導致風機葉輪磨損的發生，磨粉過程中的粉塵也得到了有效的回收。

5. It is equipped with negative pressure feeding and dust removal devices, while improving the discharge speed of materials, avoid the occurrence of worn fan impellers due to the previous positive pressure discharge in the past, and dust in the process of milling has also been effectively recovered.

6. 電氣控制部分采用國內知名品牌，主機部分采用星三角啟動方式，降低啟動電流，提高電機使用壽命。

6. The electrical control part uses the domestic well-known brand, and the host part uses the star-delta starting mode, reducing the start-up current and increasing the service life of the motor.